[A cute 4WD car that can be played right away and can be wheelie-driven] This is a 1/24 scale completed electric radio control car with a deformed lunch box, which is familiar with mini 4WD and RC. The attractive size is 190mm, which can be played anywhere indoors and outdoors. The painted and marked body is made of light and shock-resistant polycarbonate. The appearance of the raised rear hood enhances the cuteness, and the parts that make the image of two exhausts also create fun. The SW-01 chassis, which employs a gear drive 4WD, is a red part with a bright monocoque. It has a colorful body with a yellow body, yellow wheels, and black tires. RC mechanism is “Fine Spec 2.4G Proposal Set (with TRE-01)”. Equipped with a TRE-01 unit that integrates a receiver and an ESC (Electronic Speed Controller), it can run on four AA alkaline batteries, and can use LF1100 batteries.
[Equipped with gear drive 4WD and SW-01 chassis packed with fun driving]The 4WD chassis, SW-01, is packed with pleasure in an almost A5 size compact body that is 190mm long and 150mm wide. A 370 motor is set in the center of a slim and strong monocoque frame, and a gear drive 4WD that transmits power back and forth with gears is adopted. Realizes powerful driving in combination with large diameter tires with a diameter of 70 mm. A heavy battery is mounted on the upper rear of the vehicle. Wheely driving is possible just by squeezing the throttle lever of the transmitter and suddenly starting. The suspension is a strut type 4-wheel independent equipped with a coil spring. A mechanism that connects the suspension upper with the left and right arms and interlocks with the steering is adopted. The lean of the vehicle body during cornering is suppressed, and the combination of the differential gears installed on the front and rear provides excellent small turning performance. From indoor to outdoor, you can choose where you run.
[Using a 2.4G transmitter that can be easily played with multiple units] -A pre-painted body and a completed body, as well as a wheel trigger type transmitter that is easy to control are set. The RC mechanism uses a 2.4GHz radio set that can be easily enjoyed on multiple units without the need for band adjustment such as crystal replacement. 2.4GHz, which is also used for computer wireless LAN, has a one-to-one correspondence between transmitter and receiver (vehicle), so there is no worry about interference, and since the transmitter and receiver have been paired, There is no need for complicated setup work. In addition, the transmitter is a wheel trigger type that is most suitable for car operation. The switch on the back can switch between two stages of normal power with one push. Also, the thickness of the grip can be adjusted by attaching and detaching the grip cover Yes, the trigger cover can be attached and detached. Even small hands can easily grip and operate the back.
[Basic specifications]● Length 190mm, Width 150mm, Height 140mm ● Wheel base 92mm ● Tread = 122mm both front and rear ● Tire width / diameter = 28mm / 70mm both front and rear ● Frame = monocoque type ● Drive system = gear drive 4WD ● Differential gear system = planetary type ● Steering tie rod = 3 splits ● Suspension = Front and rear MacPherson strut type ● Gear ratio = 21.88: 1 ● Speed controller = ESC specification that allows smooth speed adjustment in both forward and backward travel ● Motor = 370 type
[Required separately] ● For traveling Four Tamiya AA batteries or Tamiya LF-1100 6.6V racing pack (M size) Four AA batteries for transmitter